Logo

P2544 Engine Trouble Code

Meaning of P2544 engine trouble code is : When the check engine light comes P2544 code on the first you should check is the gas cap. Pull over, retighten it, and take a look at the cap to see if it has any cracks in it. Continue driving and see if the check engine light turns off. Alternately, you can purchase a gas cap for about $3 at an auto parts store. All you need to do is take the old one off and screw on the new one. If you've already made it to the store, you might as well just replace it. While not car-threatening, it's good to take care of this right away to improve gas mileage.

P2544 Possible Solution:

P2544 Engine

Power Steering Pressure (PSP) Switch Malfunction In Key On, Engine Off Self-Test, this DTC indicates the PSP input to the PCM is high. In Key On, Engine Running Self-Test, this DTC indicates that the PSP input did not change state. Steering wheel must be turned during Key On, Engine Running Self-Test PSP switch/shorting bar damaged SIG RTN circuit open PSP circuit open or shorted to SIGRTN PCM damaged.

P2544 Code Meaning :

P 2 5 4 4
OBD-II Diagnostic Powertrain (P) Trouble Code For Engine Fuel And Air Metering (Injector Circuit Malfunctions Only) Fuel Composition Sensor Circuit Malfunction Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector) Timing Reference High Resolution Signal A Too Many Pulses

The oxygen (02) sensors on your car measure the oxygen in the exhaust to determine how rich or lean the ratio of fuel and air are in the cylinders. Optimizing this mixture means better fuel economy and fewer exhaust emissions.

P2544 OBD-II Diagnostic Powertrain (P) Trouble Code Description

P2544 engine trouble code is about Timing Reference High Resolution Signal A Too Many Pulses.

Reason For P2544 Code

The reason of P2544 OBD-II Engine Trouble Code is Fuel Composition Sensor Circuit Malfunction.

P2544 DTC specifically refers to the camshaft (cam) timing. In this case, if the cam timing is over-retarded, the engine light will be illluminated and the code will be set.